generator controller oscilloscope

GENERATOR CONTROLLER & OSCILLOSCOPE

ULTIMATE TECHNOLOGY GENSET CONTROLLER

GENSET CONTROLLER OSCILLOSCOPE INSTRUCTIONS

Push [ACK];the Be124 displays  the ‘Controller Status’ page. Push [←] to open the Main Menu. The [ENGINE METERING] menu will appear on the top of the display. Repeatedly push [ ↓ ] to select [oscilloscope]. Push [→] to activate the oscilloscope.

The oscilloscope embedded into Be124 is able to analyze the waveform of the voltages and currents. True RMS voltages, currents and frequency measurements are  indicated on the top of the display also.

The BE124, by means of software, provides automatic setup in a way to optimize the display of the waveform (auto trigger, auto range etc.).

In case you want to see details about the peaks of the waveforms, you can use the buttons [ ↓ ][ ↑ ] to display the positive peaks or negative peaks (POS= positive and NEG=negative). The Be124 will optimize the resolution automatically.

When you start the oscilloscope, internal setting is 'AUTO' (both positive and negative on the same screen). But you can change the display mode at anytime. On the left side you see examples of display for voltage VL1 to Neutral.

 

Note: over a frequency of about 150 Hz the LCD changes the presentation of the waveform. In this way, the measurements  displayed will allow you to better analyze the stability of the parameters. See am example below.

GENSET CONTROLLER CURRENT OSCILLOSCOPE 400HZ
GENERATOR CONTROLLER VOLTAGE OSCILLOSCOPE
GENERATOR CONTROLLER CURRENT OSCILLOSCOPE
GENERATOR CONTROLLER OSCILLOSCOPE

Leave a Reply