Wiring standby generator transfer switch

Standard ATS control panels are manufactured in the range 15 up to 160kVA. Other models are available on request up to 500kVA. The standard configuration features Alarm output relay and two configurable outputs. You can choose up to over 40 programmable options available in the Be28 adjustable outputs menu. If necessary, you can configure the alarm output relay as well. We recommend that you use the battery of the engine to supply the ATS control panel. The current consumption is only 70 mA in standby condition.

You are required to set up the Overload Current limit to protect the generator. You are required to limit the current flowing through the ATS panel according to the nominal short circuit current indicated in the data sheet of each ATS control panel.

Inside the panel you can add additional relay or equipment. We provided some terminal block available for the additional connections.The ATS panel can be equipped with GSM or TCP-IP server to allow you full remote control and monitoring.

[FIELD] data depends on the power rating of the generator

GO TO ATS CONTROL PANELS MAIN PAGE

GO TO BE28 ATS CONTROLLER TUTORIAL PAGE

wiring standby generator transfer switch
standby generator transfer switch design

 Bernini  Design Srl Zona Industriale, 46035 Ostiglia Italy

-VAT: IT01453040204 - REA: MN160185

email support@bernini-design.com  

  24/7/365 support 0040 721241361

POST YOUR QUESTION TO GENSET CONTROLLER BLOG

standby generator transfer switch manufacturing