Monitoreo remoto de un grupo electrógeno

BY ADDING THE BE16-K3 GSM GATEWAY AND A 4G-5G MODEM, YOU WILL GET FULL CONTROL OF YOUR POWER GENERATOR VIA A SET of SMS

PURCHASE THE GSM KIT

 249€/each

FREE-SHIPPING WORLD-WIDE

You can pay online or ask for a Proforma Invoice and pay via bank transfer

SUPPORT

+39 335 70 77 148

bernini@bernini-design.com

AMF CONTROLLER GSM-BASED MONITORING KIT

The table lists the SMS commands that will allow you full access to your standby system

STATUS It sends a request to read the engine's status and mode of operation and to read the power supply of the BE16 module.
ALARM It sends a request to get information about active alarms. You will receive the message ‘NO ALARMS’ if there is no active alarm.
GENP It sends a request to read all the instruments related to electric power.
GENV It requests to read the generator's voltages, currents and frequency.
MAINS It sends a request to read the voltages and frequency of the Mains.
ENGINE  It requests to read Battery Voltage, Speed, Oil Pressure, Fuel% %, Temperature, and h-meter.
 

CLEAR (*)

 It clears a warning or it cancels a shutdown. Please note that in case of a shutdown, the Be16 will force the BeK3 to enter the OFF mode of operation. After that, you are required to take action. Otherwise, the controller will remain in OFF mode of operation.
 OFF It commands the BEK3 to enter the OFF mode of operation and eventually shuts down the engine. The command is ignored if the BeK3 controller is in manual mode of operation.
AUTO  It forces the BeK3 to enter the AUTO mode of operation (only if it was in OFF mode). You cannot change a MODE of operation if the BeK3 is locally in MANUAL mode. So, this command is ignored in the MANUAL mode of operation
TEST It makes the BeK3 start the engine. If the option [KG TEST CONTROL] (see section 8.03 of the OEM manual) is set to [ON], when the electrical parameters are within programmed settings, the BeK3 will transfer the LOAD to the generator. This function works only if the BeK3 is in the AUTO mode of operation. Send the SMS ‘AUTO’ to stop the engine or quit the function. The BeK3 will enter the AUTO mode of operation. If all conditions are met, the BeK3 stops the engine.